Sensor Calibration

This option enables the user to calibrate all reflective type sensor.

1.To select a sensor calibration option, press the Paper Feed button.

2.Take out the paper from slip unit before calibration starts.

3.Press paper feed receipt button to start calibration.

4.After a few seconds, insert the paper into slip unit.

5.The printer will perform calibration on the following sensors.

•TOF (Top Of Form) Sensor for slip unit

•BOF (Bottom Of Form) Sensor for slip unit

•FLS (Flip Sensor) Sensor for slip unit if installed

Note:  When the calibration is completed the printer will return to the Mfg Adjustment Menu. If the test is unsuccessful the printer will halt. To recover, reset print and check if sensors are connected and working properly.

6.To review the results of the sensor calibration test perform Print Current Setting. If the results show all zeros there is a problem with that sensor. Check to ensure that the sensor is plugged in properly. If so, then replace sensor.