Removing R5 Tri-Light/Lane Light Assembly and Pole

To remove the 7350 (R5) Tri-Light/Lane Light assembly and pole, follow these steps:

1.Turn off the NCR SelfServ Checkout software and hardware systems.

2.Open the Upper Cabinet Door.

3.Do the following:

•Disconnect the R5 Tri-Light cable from the 7360 I/O Box, as shown in the image below.

•Disconnect the R5 Tri-Light/Lane Light power cable.

Note:  The R5 Tri-Light/Lane Light power cable is conected to the UPS if the unit is configured with a UPS. If the unit is not configured with a UPS, the power cable is connected to the Power Strip.

.

4.Remove two screws securing the pole to the unit.

5.Carefully lift the Tri-Light/Lane Light assembly and pole out of the unit.

6.Install the R6L Lite Tri-Light/Lane Light Pole. For more information, refer to Installing R6L Tri-Light/Lane Light Pole.