Linux

Linux installers for NCR RealScan Scanner Communicator come in the following format:

NCRRSScannerCommunicatorLinuxSetup

There are two modes to install the NCR RealScan Scanner Communicator on Linux. In performing the installation, make sure the following is considered:

  • You may first add an execute attribute to the installer before executing the installer. To add an execute attribute, type chmod +x <installer>, where <installer> is the name of the installer you want to run.

The following procedures explain how to run the installer in each mode.

GUI

In the terminal, type the following:

./NCRRSScannerCommunicatorLinuxSetup

Silent

In the terminal, type the following:

./NCRRSScannerCommunicatorLinuxSetup –mode silent

To check if the installation is successful, browse through /usr/local/NCR/NCRRealScan/ScannerCommunicator.