Buffered Printing

Printers start to accumulate print data when Buffered Printing Setting is enabled and start to print under any of the following conditions:

• When the following commands are received:
  • FF, Print and return standard mode
  • ESC BEL, Generate tone
  • ESC L, Select page mode
  • ESC i, Full cut
  • ESC m, Partial cut
  • GS V, Select cut mode and cut paper
  • US t, Print Configuration Form
• When the accumulated print lines is 80 or more.

Status command will be executed even when Buffered Printing is enabled.

When Buffered Printing is enabled, GS ! command set height magnification of 3x or larger is ignored.

When Buffered Printing is disabled and height magnification is set to 3x or larger by GS ! command, subsequence set m =1 forces the height magnification to 2x.

ESC { n Select or Cancel Upside & Down Printing Mode is ignored when Buffered Printing is enabled.

Accumulated data is cleared by the Clear Buffer command.