5907-K400-V001/V002 7” Customer Display 3-in-1 Payment
This kit provides a stand to install the 3-in-1 Payment device on the NCR XL7W (5907) Display.
Kit Contents
5907-K400-V001
5907-K400-V002
Installation Procedure
1.Install the 3-in-1 Payment Device on the stand.
a.Remove the Cover (4 screws).
b.Connect the USB Cable to the 3-in-1 Payment Device. Position the Payment Device on the Cover and route the Cable as shown.
c.Reinstall the Cover (4 screws).
Note: Ensure the Payment Device is positioned as shown in the cross-sectional image below.
2.Install the stand on the Display.
a. Install the stand on the back of the Display (4 screws).
b.Route the Payment Device USB Cable and Display Port USB Cable through one of the Cable Strain Relief Tabs and secure both cables to the Tab with a zip tie.
c.Connect the Payment Device USB Cable and Display Port USB Cable to the Display.
