5907–K302/K303 XL7W Standalone Pole Mount/Tilt

This kit provides a bracket to mount a non-touch NCR XL7W (5907) Display to a tilt pole.

Note:  A swivel mount (5977-K160) is required to mount the bracket on a pole.

Kit Contents

5907-K302 XL7W Standalone Pole Mount/Tilt (Black)

Item	P/N	Description
1	497-0518363	Adapter, Pole Mount, XL7W
2	006-8615964	Screw, M4x8, Machine, Phillips, Pan Head, Steel, Black
3	006-8617763	Screw, M4x12, Machine, Phillips, Pan Head

5907-K303 XL7W Standalone Pole Mount/Tilt (White)

Item	P/N	Description
1	497-0520995	Adapter, Pole Mount, XL7W, White
2	006-8623674	Screw, M4x0.7Px8, Machine, Phillips, Pan Head
3	006-8612592	Screw, M4x0.7Px12, Phillips, Pan Head, SEMS, Stainless Steel

Installation Procedure

1.Connect the USB end of the Display Cable to the back of the Display. Tighten the thumbscrew.

Note:  Avoid overtightening the thumbscrew by turning it only until the silver knurled portion touches the black plastic overmold. Overtightening the thumbscrew damages the connector on the board.

2.Insert the cable through the Bracket opening.

3.Install the Bracket on the back of the Display (4 screws).

4.Insert the cable through the Pole.

5.Mount the forks of the Bracket onto the ribs of the pole swivel and then snap them in place.

6.Connect the Display Cable to the host terminal.