5907–K301 XL7W SpacePole

This kit provides a bracket to mount the NCR XL7W (5907) Display to a SpacePole.

Kit Contents

Installation Procedure

1.Connect the USB end of the Display Cable to the back of the Display. Tighten the thumbscrew.

Note:  Avoid overtightening the thumbscrew by turning it only until the silver knurled portion touches the black plastic overmold. Overtightening the thumbscrew damages the connector on the board.

2.Install the Bracket on the back of the Display (4 screws).

3.Mount the Display on the Pole. Using an allen key, tighten the set screw on the connection arm to secure it to the Pole.

4.Route the cable through the Cable Management Clip.

5.Connect the Display Cable to the host terminal.