5907–K030 XL7W Wedge Stand

This kit provides a wedge stand for the NCR XL7W (5907) Display.

Kit Contents

Dimensions

Installation Procedure

1.Connect the USB end of the Display Cable to the back of the Display. Tighten the thumbscrew.

Note:  Avoid overtightening the thumbscrew by turning it only until the silver knurled portion touches the black plastic overmold. Overtightening the thumbscrew damages the connector on the board.

2.Remove the Cover from the Wedge Stand.

a.Swing the Cover upward to detach. The Cover has a snap fit connection on the bottom.

b.Pull Cover in the direction shown to unlatch.

3.Install the Wedge Stand on the back of the Display (4 screws).

4.Route the Cable through the slot between the tabs and make sure the Cable is behind the tab.

5.Reinstall the Wedge Stand Cover.

a.Insert the tabs of the Cover into the Wedge Stand.

b.Swing the Cover down until it latches into place.

6.Connect the Display Cable to the host terminal.