Counter Mount for Black C730

Introduction

This kit provides a counter mount for a black C730 customer display with Powered USB and DVI - HDMI cables when used with the P1532 POS (7734).

1.Loosen the screw (1).

2.Remove the Back Connector Cover.

3.Remove the screws (2) and the Stand Cover.

4.Attach the black C730 customer display to the stand. Tighten the screws (4).

5.Plug in the DVI and the 12 V Powered USB cables into the dedicated ports.

6.Replace the Stand Cover and secure with the screw (1).

7.Replace the Back Connector Cover and secure with the screws (2).

8.Loosen the thumbscrew and open the CableLock™ Cover.

9.Route the cables under the stand and up through the CableLock™ Cover.

10.Route the cables into the cable clamps. Install the expansion blank plate and cable clamps (2) and secure with screws (2).

Note: If the POS includes an expansion, install the cable clamps under the expansion and secure with screws (2).

11. Close and secure the CableLock™ Cover with a thumbscrew.

12.Connect the cables to the HDMI and 12 V Powered USB ports.

Note: Ensure that the USB cables do not hang loose. Adjust the cables into the cable clamps as needed.